ANALISIS TEGANGAN THERMAL PADA TROMOL REM TRUK DENGAN KAPASITAS ANGKUT 6 TON
Abstract
This paper presents drum brakes thermal stress analysis for 6 ton truck capacity, due to friction between shoe and drum for two leading shoe brakes type. The mechanical and thermal loading are analyzed for various road conditions such as straight path, curved, and downhill path, with various value of deceleration. Based on the transient heat transfer, the drum temperature distribution are calculated for various deceleration and braking time period. Using finite element techniques, the thermal stressses are obtained and the results are compared to the actual failures evidences of brake drums. It is obeserved that the real heat crack locations are in agreement with the computed stressed areas. Based on the pressure and temperature distribution, the wear rate can be obtained to estimate the technical life of the brake drum.
References
Newcomb, T.P. and Spurr, R.T., Automobile Brakes and Braking Systems, Chapman and Hall Ltd, 1969.
Newcomb, T.P., Day, A.J., 1979, "The Use of Finite Element Analysis to Predict Radial Temperature Distributions in an Annular Brake Path" , Proceeding 5th leeds-lyon symposium on tribology, pp.333-340.
Limpert, R., 1992, Brake Design and Safety, SAE Inc, Warrendale, USA.
Daimaruya, M. and Kobayashi, H., 1997, Thermoelasto-Plastic Stresses and Thermal
Distortions in a Brake Drum, Journal of Thermal Stress.
Fuad, K., Daimaruya, M. and Kobayashi, H., 1994, "Temperature and Thermal Stresses in A Brake Drum subjected to Cyclic Heating," Journal of Thermal Stress, pp. 515 - 527.
Suprihanto, A., 2001, Identifikasi Penyebab Retak Teromol Rem Bus/Truk Produk PT. Suyuti Sido Maju, Tesis Magister, Program Studi Teknik Mesin, Institut Teknologi Bandung.
Puja, I. W., Reza, Ako, H., 2001, "Analisis Tegangan dan Modifikasi Tromol Rem Truk Kapasitas Angkut 6 Ton" , Proceeding Elemen Hingga 2001, pp.50-59.
Puja, I.W., Suprihanto, A., Suhartanto, U.., "Failure Investigation And Material Improvement For Drum Brakes Produced By Traditional Foundary Industries" , The 5th International Conference on Fracture and Strength of Solids, October 20-22, 2003, Sendai, Japan.
Day, AJ, 1988, "An Analysis of Speed, Temperature and Performance Characteristic of Automotive Drum Brake" , Transaction of the ASME Journal of Tribology, vol. 110, pp. 298-305.
Tampubolon, H.A., 2002, Analisis Tegangan Thermal dan Keausan Rem Drum Pada Truk dengan Daya Mesin 192 HP, Tesis Magister, Program Studi Teknik Mesin, Institut Teknologi Bandung.
Angus HT, 1976, "Cast Iron Physical and Engineering Properties" , Buttherworths.
ASM Handbook, 1990, "Properties and Selection Irons, Steels and High Performance Alloys" , volume 1 edisi 10.
