Studi Eksperimental Penggunaan Pen-Binder dan FRP Sebagai Perkuatan Tulangan Tidak Standar Pada Kolom Lingkaran

https://doi.org/10.5614/jts.2017.24.1.7

Authors

  • Anang Kristianto Program Studi Teknik Sipil U.K. Maranatha, Jl. Suria Sumantri 65 Bandung
  • Yosafat Aji Pranata Program Studi Teknik Sipil U.K. Maranatha, Jl. Suria Sumantri 65 Bandung
  • Iswandi Imran Program Studi Teknik Sipil ITB, Jl. Ganesha No. 10 Bandung

Keywords:

Perkuatan, kolom, FRP, pen-binder, daktilitas.

Abstract

Abstrak

Penelitian ini dilakukan untuk mengevaluasi peningkatan kekuatan yang terjadi pada spesimen kolom lingkaran beton bertulang dengan tulangan pengekang tidak standar yang diberi perkuatan pen-binder dan perkuatan FRP. Benda uji berupa kolom lingkaran dengan diameter 190 mm dan tinggi 480 mm dengan mutu beton 15 MPa. Benda uji terdiri dari 4 jenis yaitu kolom dengan tulangan sengkang spiral, kolom dengan tulangan tidak standar/lingkaran, kolom dengan tulangan tidak standar yang diberi perkuatan pen-binder dan kolom dengan tulangan tidak standar dengan perkuatan FRP. Untuk setiap jenis kolom dibuat 3 buah benda uji yang sama. Pengujian dilakukan dengan uji tekan konsentris hingga kolom mengalami kegagalan. Hasil penelitian menunjukan bahwa penggunaan pen-binder dan FRP pada tulangan pengekang tidak standar memberikan peningkatan kapasitas aksial berturut-turut sebesar 18% dan 58% dari kolom dengan tulangan spiral. Pen-binder dapat digunakan sebagai solusi perkuatan sederhana untuk tulangan pengekang tidak standar dan lebih ekonomis daripada FRP.

Abstract

This study was conducted to evaluate the increasing strength of circular reinforced concrete column specimens with non-compliance confinement reinforcements strengthened by pen-binder and FRP. The test specimens were circular column 190 mm diameter and 480 mm height with 15 MPa concrete strength. The test specimens consist of 4 types of columns where there is a column with spiral reinforcement, columns with non compliance reinforcements, a column with non-compliance reinforcement strengthened by pen-binder and columns with non-compliance reinforcements strengthened with FRP reinforcement. Three specimens were made for each type of column. The axial concentric test was done until the column specimen failure. Test results showed that the use of pen-binder and the FRP with non-compliant confining reinforcement improved axial capacity by 18% and 58% respectively as compared to the columns with spiral reinforcements. Pen-binder can be used as a simple solution for non compliant confining reinforcement strengthening and more economical than FRP.

 

References

ACI 440.2R-02, Guide for the Design and Construction of Externally Bonded FRP Systems for Strengthening Concrete Structures, ACI Committee 440.

ACI Committee 318M-05, Building Code Requirements for Reinforced Concrete and Commentary, (ACI 318M-05 ), American Concrete Institute, Detroit.

Kristianto, A., dkk., 2011, Studi Eksperimental Penggunaan Tulangan Pengekang Tidak Standar yang dimodifikasi pada Kolom Persegi Beton Bertulang. Jurnal Teknik Sipil ITB (ISSN 0853-2982), Vol 18. No.3 Desember 2011.

Kristianto, A., dkk., 2012, Confinement of Reinforced-Concrete columns with Non-Code Compliant Confining Reinforcement plus Supplemental Pen-Binder, ITB Journal of Engineering Science (ISSN 1978-3051) Vol. 44 No.3, November 2012.

Richart, et al., 1928, A Study of Failure of Concrete Under Combined Compression Stresses, Engineering Experiment Station Bulletin, No. 185, University of Illinois, pp 104, Urbana.

Richart, et al., 1929, The Failure of Plain and Spirally R.C in compression, Engineering Experiment Station Bulletin, No. 190, University of Illinois, pp 14, Urbana.

Razvi, S.R., and Saatcioglu M., 1994, Strength and Deformability of confined High-Strength Concrete Columns, ACI Structural Journal, V. 91, No. 6, Nov-Dec. 1994, pp. 1-10.

Saatcioglu, M., and Razvi, S.R., 1992, Strength and Ductility of Confined Concrete, Journal of Structural Engineering, ASCE, V. 118, No. 6, June 1992, pp. 1590-1607.

Standar Nasional Indonesia (SNI 2847-2013), 2013, Persyaratan Beton Struktural untuk Bangunan Gedung, Badan Standardisasi Nasional (BSN).

Published

2017-04-13

Issue

Section

Articles